罐和盖耐压综合检测仪 CEBT-100

Canneed “CEBT-100罐和盖耐压综合检测仪Buckle Tester for Can andEnd”有四种模式

1、罐底耐压（包括直身罐、缩颈罐）

2、盖耐压

3、飞舌测试

4、封盖之后的盖耐压

CEBT-100能检测不同尺寸的罐和盖。将样品放在固定夹具上，加压，压力上升至设定值，压力的上升速度可以在检测仪上设定。样品变形测试终止，屏幕显示*大压力值。

优点：

1)       “CEBT-100”是制罐行业的标准仪器

2)       带RS232C数据输出，可以向SPC发送数据

3)       采用了PLC触摸屏显示控制系统

4)       加压速度可调，升压曲线可设定

5)       内置“气动增压阀”，可将气源压力增加为输入压力的1到2倍

6)       高精度

7)       带校准口，方面校准

8)       多种**设施

9)       过载保护

技术参数：

量程：0-900 Kpa（即0.9Mpa）

分度：1 KPa

数据线：RS232C

电源：230V/50Hz

气源：0.5 Mpa

尺寸：770 x 500 x 1100 (W x D x H)

重量：80kg

 

The “Canneed CEBT-100Buckle Tester for Can and end” determines the exact pressure atwhich the Can and End begins to buckle. With 4 Measuringmode:

1.       Buckle Bottom For Can

2.       Peak Test For Free End

3.       Missile Test For Free End

4.       Peak Test For Seamed End

The sample is placed inthe holder. After closing the door pressure is applied. Fastpressure increase up to the expected value, from there the “speedof pressure increase” may be set within the device. The test isterminated as soon as the can or end buckles. The maximum pressurevalue is shown in the display. Any can and end of varyingdimensions may be tested: inserts are available that can beexchanged within seconds.

Feature:

*Industry Standard

*Program Logic Control System (PLC) Controlled

*LCD touch-screen Display

*Rs-232 Communications Capability

* Overload Protection

*Test Point For Calibration

*“speed of pressure increase” may be set

Technical data (changesreserved):

Measure range: 0-900 Kpa

Resolution: 1 Kpa

Rear Panel: RS232 serial output

Power supply: 115/230V/50…60Hz

Pneumatic supply: 10bar

Dimensions: 770 x 500 x 1100 (W x D x H )

Weight: 80 kg

http://www.canneed.com