D06F减压阀霍尼韦尔Honeywell D06F-1/2A,D06F-1/2B,D06F-3/4A,D06F-3/4B,D06F-1A

日期：2025-02-20 04:54

浏览次数：1245

霍尼韦尔Honeywell D06F减压阀
霍尼韦尔减压阀工作原理
减压阀的工作原理建立在两个对应的作用力相互平衡的基础上——弹簧向下的作用力和隔膜向上的作用力。当
打开龙头用水时，出口压力也即是隔膜压力降低，弹簧的作用力大于作用在隔膜上的水的压力，阀门打开。出
口压力下降直至隔膜和弹簧上的作用力再次平衡为止。
由于平衡式阀芯设计，无论阀门开启或者关闭，入口压力都不会影响出口压力。因此，入口压力波动不会造
成出口压力的波动，出口压力维持在一定范围内。
典型应用
Honeywell 减压阀可设定和稳定入户水压，节约用水
量、保护用水设备免受水锤的影响。在它的特性范围
内，也可应用于工业或商业领域。安装了减压阀后，
不仅可以舒适**用水，避免超压带来的损害，也可
节约用水量，减少资源浪费。
● 民用住宅
● 公共建筑，酒店、医院、商业区、学校、运动场馆、
图书馆...
● 生活热水系统
● 预防超压现象发生的水系统，
● OEM 设备（洗碗机、净水器、喷水机、洗车设备..)
● 工业应用如：水，压缩空气、氮气
材质
● 防脱锌黄铜外壳
● 防脱锌黄铜螺纹连接
● 高质量合成材料阀芯
● 不锈钢过滤网孔
● 高合成材料的弹簧阀帽
● 合成透明材质或防脱锌黄铜滤碗
● 钢制调整弹簧
● 纤维增强NBR 隔膜
● NBR 密封
应用范围
介质水，压缩空气、氮气
（DIN EN 12502 标准范围内）
入口压力透明滤碗16bar
黄铜碗25bar
出口压力1.5 ~ 6.0bar

APPLICATION
According EN 806-2 pressure reducing valves of this type
protect household water installations against excessive
pressure from the supply. They can also be used for
industrial or commercial applications within the range of
their specification.
By installing a pressure reducing valve, pressurisation
damage is avoided and water consumption is reduced.
The set pressure is also maintained constant, even when
there is wide inlet pressure fluctuation.
Reduction of the operating pressure and maintaining it at a

constant level minimizes flow noise in the installation.

APPROVALS
• DVGW
• WRAS (up to 23 °C)
SPECIAL FEATURES
• Inlet pressure balancing – no influence on outlet
pressure by fluctuating inlet pressure
• Up to size 11/4" approved by LGA for low noise, Group 1
without limitations
• The valve insert is of high-quality synthetic material
and can be fully exchanged
• The outlet pressure is set by turning the adjustment
knob
• The set pressure is directly indicated on the set point
scale
• The adjustment spring is not in contact with the
drinking water
• Integral fine filter
• Also available without fittings
• Conforms to BSEN 1567
• All materials are UBA conform
• ACS certified

TECHNICAL DATA
Note: Use the SM06T brass filter bowl, if the valve can be exposed to
UV radiation or solvent vapors.
Media
Medium: Drinking water
Connections/Sizes
Connection sizes: 1/2" - 2"
Nominal sizes: DN15 - DN50
Pressure values
Max. inlet pressure with clear
filter bowl:
16 bar
Max. inlet pressure with
brass filter bow:
25 bar
Outlet pressure: 1.5 - 6 bar
Preset outlet pressure: 3 bar
Min. pressure drop: 1 bar
Operating temperatures
Max. operating temperature
medium (10 bar/brass filter
bowl):
70 °C
Max. operating temperature
medium accord. to EN 1567:
30 °C

METHOD OF OPERATION
Spring loaded pressure reducing valves operate by means of
a force equalising system. The force of a diaphragm
operates against the force of an adjustment spring. If the
outlet pressure and therefore diaphragm force fall because
water is drawn, the then greater force of the spring causes
the valve to open. The outlet pressure then increases until
the forces between the diaphragm and the spring are equal
again.
The inlet pressure has no influence in either opening or
closing of the valve. Because of this, inlet pressure
fluctuation does not influence the outlet pressure, thus
providing inlet pressure balancing.
TRANSPORTATION AND STORAGE
Keep parts in their original packaging and unpack them
shortly before use.
The following parameters apply during transportation and
storage:

INSTALLATION GUIDELINES
Setup requirements
• Install in horizontal pipework with filter bowl
downwards
• Install shut-off valves
• The device downstream should be protected by means
of a safety valve (installed downstream of the pressure
reducing valve). In these cases the delivery pressure of
the pressure reducing valve shall be set to at least 20 %
below the response pressure of the pressure reliefvalve
according to EN 806-2
• The installation location should be protected against
frost and be easily accessible
• Pressure gauge can be read off easily
• With clear filter bowl, degree of contamination can
be easily seen
• Simplified maintenance and cleaning
• Install downstream of the filter or strainer
• Provide a straight section of pipework of at least five
times the nominal valve size after the pressure
reducing valve (in accordance with EN 806-2)
• Requires regular maintenance in accordance with
EN 806-5

Parameter Value
Environment: clean, dry and dust free
Min. ambient temperature: 5 °C
Max. ambient temperature: 55 °C
Min. ambient relative
humidity:
25 % *
Max. ambient relative
humidity:
85 % *

联系人:刘长河 185 0023 9293

下一篇：霍尼韦尔honeywell VSHB 系列静态平衡阀 VSHB16F-050、VSHB16F-065、VSHB16F-080、VSHB16F-100、VSHB16F-125、VSHB16F-150
上一篇： VDP系列动态压差平衡阀霍尼韦尔honeywell DN25-DN250

D06F减压阀 霍尼韦尔Honeywell D06F-1/2A,D06F-1/2B,D06F-3/4A,D06F-3/4B,D06F-1A

D06F减压阀霍尼韦尔Honeywell D06F-1/2A,D06F-1/2B,D06F-3/4A,D06F-3/4B,D06F-1A