Buehler镶嵌机SimpliMet 3000型产品特点：
· 适用于有多种镶嵌样需求且镶嵌尺寸不同的实验室。
· 存储和撤销5种不同的程序，降低复杂性和消除错误， 提供灵活性来满足多变的实验室要求
通过选择不同尺寸的模具来优化各种各样的试样大小。节约镶嵌介质并提升镶嵌质量
Specifications
Operation
Automatic electro-hydraulic
Power Source
85-264VAC, 50/60Hz, 1 phase
Molding Pressure
1200 - 4400psi [80 - 300bar] in 100psi [5bar] increments
Molding Temperature
120 - 360°F [50 - 80°C] in 20°F [10°C] increments
Heating Power
1500Watt @ 115/230VAC
Heating Time
0 - 20 minutes in 10 second increments
Cooling Time
0 - 30 minutes in 10 second increments
Mold Type
Cylindrical, including upper and lower rams and duplex mold spacer
Closure Type
Insluated bayonet with piston indent
Mold Diameters
1in, 1.25in, 1.5in, 2in, 25mm, 30mm, 40mm, 50mm
Touch-pad Controls
On/Off; Heat Time; Cool Time; Molding Temperature; Molding Pressure; Mold Size; Ram Up/Down; Maunal Cool; Cycle Start; Cylinder Open; Unit of Measure; Language and also including Thermoplastic; Load and Save Methods
Units of Measure
Imperial or Metric
Water Flow Rate
0.5gal/min [2ℓ/min] minimum
Water Pressure
45-75psi [3-5bar]
Control Voltage
24VDC
Method Programmability
4 Buehler, Preprogrammed Methods per mold size; 25 User Definable Methods
Preload Pressure
0 - 400psi [0 - 30bar] in 50psi [5bar] increments
Thermoplastic Function
Automatically sets correct parameters for thermoplastic resins such as TransOptic™ and cools the mount in a controlled, linear fashion
Compliance
In accordance with EC Directives
浙公网安备 33020502000225号
