企业信息
第16年
- 入驻时间: 2008-11-14
- 联系人:曾霏
- 电话:0769-23030558
-
联系时,请说明易展网看到的
- Email:dz511718@163.com
- 拉力试验机
- 拉力机夹具
- 耐磨试验机
- 电子产品试验机
- 纺织业试验机
- 塑胶橡胶试验机
- 制鞋业试验机
- 电线电缆试验机
- 皮革业试验机
- 箱包类试验机
- 胶带试验机
- 曲线仪
- 安规
- 雾度计
- 箱包试验机
- 推力测试仪
- 新产品
- 非标定制
- 燃烧系列
- 纸品包装试验机
- 恒温恒湿试验箱
- 可程式恒温恒湿试验箱
- 桌上型恒温恒湿试验箱
- 紫外耐气候试验箱
- 氙灯耐气候试验箱
- 高温老化试验箱
- 高低温试验箱
- 高低温湿热试验箱
- 高低温交变湿热试验箱
- 可程式高低温试验箱
- 桌上型高低温试验箱
- 环境试验箱
- 步入式环境试验室
- 盐雾试验箱
- 砂尘试验箱
- 电池试验机
- 雨伞试验机
- 玩具婴儿车试验机
- 安规试验机
- 疲劳试验机
- 硬度计
- 家具地板试验机
- 电子测试仪器
- 耗材
- ROHS检测仪
- 真空试验箱
- 光学测量仪器
- 三坐标测量机
- 石膏砖瓦试验机
- 量具量仪
- 色差仪
- X荧光光谱仪
文章详情
水洗色牢度试验机的测试方法和标准
日期:2024-11-24 02:27
浏览次数:907
摘要:
FASTNESS TO WASHING
水洗牢度测试方法和标准
Method: UNI EN 20105794 da C01 a C05
方法标准:UNI EN 20105794 自C01到C05
Washing by hand, test to carry out in laboratory
实验室手洗牢度测试
Detergent required is washing powder without chloride 4 g/l, use150 g of this detergent solution for
要求使用不含氯洗衣粉。洗衣粉的加入量为4克/升。取溶有洗衣粉的水溶液150克,
the fabric sample of dimension 10x4 cm for 30 minutes at requiredtemperature in moving bath.
将10X4cm大小的样布放入溶液中,将溶液设置在要求的温度,摇洗30分钟。
The fabric should be washed together with white fabric in order tocheck the losing colour.
样布必须与一片白布一同洗涤,以检测是否有洗下的颜色。
Temperature required depends on items, 20 癈, 30癈, 40 癈, 60癈. Lowtemperature for delicate
水洗的温度取决于被测样布的性质, 分别为20 癈, 30癈, 40 癈, 60癈. 易损或化纤样布适用
and synthetic items, high temperature for white and coloured.
较低的洗涤温度,白色或其它有色样布可用较高的洗涤温度。
Method: UNI EN ISO 105 C06/99, AATCC 61/69
方法标准:UNI EN ISO 105 C06/99, AATCC 61/69
By washing machine, test to carry out in laboratory
实验室机洗牢度测试。
Detergent required is washing powder without chloride, the fabricsample of dimension 50 x50 cm,
测试用的洗衣粉中要求不含氯。样布的大小为50X50cm。
wash the sample together with a white fabric in order to checklosing colour.
将样布与一片白色面料一起洗涤, 以测试颜色脱落情况。
The machine cycle to use is according to nature of the items:
机洗条件取决于所册样不的性质:
white cotton items: 60 癈 for 60 minutes
白色全棉布: 60癈, 60 分钟。
cotton coloured items: 40 癈 for 40 minutes
有色全棉布: 40癈, 40分钟。
synthetic items: 40癈 for 30 minutes, soft spinning
化纤面料: 40癈, 30分钟, 轻洗。
wool and delicate: 20 癈 for 30 minutes, no spinning
毛料及其它轻质面料: 20癈, 30分钟, 无搅洗。
By washing machine, domestic and commercial washing
洗衣机可为家用或商用洗衣机。
Detergent required is washing powder without chloride, machinecycle for coloured items is 40 癈
洗衣粉为无氯洗衣粉。有色样布的水洗条件为40癈, 40-60分钟。
for 40 – 60 minutes.
Items labelling
牢度的标识
Fastness according to international commercial agreements among theparts should be more than 3/
根据国际商业协议,色牢度要求不低于3/4级(根据颜色可分为1-5级, 1为差, 5为好),
4 (according to grey scale 1-5, 1 means bad, 5 means good), but thefastness grade depends on several factors like type of items, typeof dyestuff and nature of the products, consequently the
但是色牢度往往与很多因素相关, 例如成衣的类型,染料的种类,面料的性质等等,
fastness grade could be less.
所以牢度等级有可能会更低。
Before labelling as fast to washing at certain temperature,specially for high temperature, needs to
在成衣上标识某温度下的水洗牢度, 特别是较高温度下的水洗牢度时,还有必要检测其
check also other parameters like fastness of colours (on printingand on dyed ground), dimensional 它参数,色牢度(指印花颜色和面料的染色), 缩水率等。
stability of items.
Commercially is approved for items like T shirt, shorts and sportwear cloths (cotton , T/C, PES) 3
对T-恤,内衣或运动服(全棉, T/C, PES),商业上认可的标准是:
washes at 40 癈 for 40 minutes, dried each times with the followingvalue:
40癈水洗40分钟,洗3次, 每次干燥, 色牢度应符合:
Washing fastness 4 (on printing) 印花水洗牢度 4级,
3/4 (ground) 面料色牢度 3/4级。
Dimensional stability max 5 % 缩水 小于 5%。
水洗牢度测试方法和标准
Method: UNI EN 20105794 da C01 a C05
方法标准:UNI EN 20105794 自C01到C05
Washing by hand, test to carry out in laboratory
实验室手洗牢度测试
Detergent required is washing powder without chloride 4 g/l, use150 g of this detergent solution for
要求使用不含氯洗衣粉。洗衣粉的加入量为4克/升。取溶有洗衣粉的水溶液150克,
the fabric sample of dimension 10x4 cm for 30 minutes at requiredtemperature in moving bath.
将10X4cm大小的样布放入溶液中,将溶液设置在要求的温度,摇洗30分钟。
The fabric should be washed together with white fabric in order tocheck the losing colour.
样布必须与一片白布一同洗涤,以检测是否有洗下的颜色。
Temperature required depends on items, 20 癈, 30癈, 40 癈, 60癈. Lowtemperature for delicate
水洗的温度取决于被测样布的性质, 分别为20 癈, 30癈, 40 癈, 60癈. 易损或化纤样布适用
and synthetic items, high temperature for white and coloured.
较低的洗涤温度,白色或其它有色样布可用较高的洗涤温度。
Method: UNI EN ISO 105 C06/99, AATCC 61/69
方法标准:UNI EN ISO 105 C06/99, AATCC 61/69
By washing machine, test to carry out in laboratory
实验室机洗牢度测试。
Detergent required is washing powder without chloride, the fabricsample of dimension 50 x50 cm,
测试用的洗衣粉中要求不含氯。样布的大小为50X50cm。
wash the sample together with a white fabric in order to checklosing colour.
将样布与一片白色面料一起洗涤, 以测试颜色脱落情况。
The machine cycle to use is according to nature of the items:
机洗条件取决于所册样不的性质:
white cotton items: 60 癈 for 60 minutes
白色全棉布: 60癈, 60 分钟。
cotton coloured items: 40 癈 for 40 minutes
有色全棉布: 40癈, 40分钟。
synthetic items: 40癈 for 30 minutes, soft spinning
化纤面料: 40癈, 30分钟, 轻洗。
wool and delicate: 20 癈 for 30 minutes, no spinning
毛料及其它轻质面料: 20癈, 30分钟, 无搅洗。
By washing machine, domestic and commercial washing
洗衣机可为家用或商用洗衣机。
Detergent required is washing powder without chloride, machinecycle for coloured items is 40 癈
洗衣粉为无氯洗衣粉。有色样布的水洗条件为40癈, 40-60分钟。
for 40 – 60 minutes.
Items labelling
牢度的标识
Fastness according to international commercial agreements among theparts should be more than 3/
根据国际商业协议,色牢度要求不低于3/4级(根据颜色可分为1-5级, 1为差, 5为好),
4 (according to grey scale 1-5, 1 means bad, 5 means good), but thefastness grade depends on several factors like type of items, typeof dyestuff and nature of the products, consequently the
但是色牢度往往与很多因素相关, 例如成衣的类型,染料的种类,面料的性质等等,
fastness grade could be less.
所以牢度等级有可能会更低。
Before labelling as fast to washing at certain temperature,specially for high temperature, needs to
在成衣上标识某温度下的水洗牢度, 特别是较高温度下的水洗牢度时,还有必要检测其
check also other parameters like fastness of colours (on printingand on dyed ground), dimensional 它参数,色牢度(指印花颜色和面料的染色), 缩水率等。
stability of items.
Commercially is approved for items like T shirt, shorts and sportwear cloths (cotton , T/C, PES) 3
对T-恤,内衣或运动服(全棉, T/C, PES),商业上认可的标准是:
washes at 40 癈 for 40 minutes, dried each times with the followingvalue:
40癈水洗40分钟,洗3次, 每次干燥, 色牢度应符合:
Washing fastness 4 (on printing) 印花水洗牢度 4级,
3/4 (ground) 面料色牢度 3/4级。
Dimensional stability max 5 % 缩水 小于 5%。