三信亚太科技(深圳)有限公司
新增产品
|
公司简介
注册时间:
2012-03-13
联系人:
电话:
Email:
首页
公司简介
产品目录
公司新闻
技术文章
资料下载
成功案例
人才招聘
荣誉证书
联系我们
产品目录
美国 NDT Systems 公司产品系列
超声成像系统
胶接检测仪系列
探伤仪系列
测厚仪系列
X射线探伤仪系列
奥林巴斯
3DCT电路板扫描系统
埋地管道防腐层检测系统
其他探伤仪系列
常规超声检测
相控阵检测
便携式TOFD检测
自动天然气管道扫描仪
当前位置:
首页
>>>
技术文章
>
技术文章
检测管道腐蚀或及其内衬橡胶胶接
Application Note 002
操作说明002
Inspection of rubber lined metal pipes or vessels for disbonds
检测管道腐蚀或容器与其内衬橡胶脱胶
Motivation: Many metal pipes or vessels have rubber or other linings on the inside diameter for
transport or mixing of certain fluids. There is a common requirement to be able to inspect the bonding
between the metal and liner.
案例:许多金属管道或容器里有橡胶或其它内衬用以混合液体,一般需要检查金属和内衬橡胶之间的结合。
Principle: By using a transducer that can penetrate the rubber through the bondline, the amplitude of
the interface can be measured with a flaw gate. Good bonding will attenuate the signal. A disbond will
return a higher amplitude echo since the sound cannot now penetrate the rubber.
原理:我们需要选用一个能穿透(良好胶接口下的)橡胶的探头,然后利用缺陷闸门检测回波的波幅。良好
的胶接口会令信号衰减。在脱胶的地方由于声波没法穿透空气,会有较高幅度的回波反射。
Challenge: Initial tests with a 5MHz tranducer showed that we did not penetrate the rubber since a
known disbond was not resolved. Therefore a lower frequency 2.25MHz was used with a composite
construction to give better penetration and an improved signal to noise ratio. A dual-element was also
required because of the curvature of the pipe; a single element was too sensitive to rocking of the
transducer.
分析:起初我们使用5MHz的探头,由于声波没法穿透橡胶,因此工件上已知的脱胶部位无法显示出来。
因此我们使用频率稍低的2.25MHz探头,能穿透橡胶和改进了信噪比。另外由于管道有弧度,所以
需要使用双晶探头。因为单晶探头无法消除盲区。
Solution:
· Raptor Imaging Flaw Detector
· RCA-10 or RCA-18 scanner
· Dual-element 2.25MHz composite transducer (1/4”) Part No. AE07E06
方案:
1.Raptor成像探伤仪
2.RCA-10或RCA-18扫查器
3.双晶2.25MHz探头,编号:AE07E06
Results:
结果:
Figure 1. C-scan of pipe. Initial results using 5MHz dual-element. Variable shows % flaw gate height.
图1 C-扫描管道。初步结果使用5MHz的双晶探头。不能明确显示已知脱胶位置。
Figure 2. C scan of pipe using 2.25MHz transducer. Variable shows % flaw gate height.
图2 使用2.25MHz的探头。可明显看到回波幅度较大位置代表脱胶位置。
Conclusion: Pipes and vessels with bonded internal liners can be inspected for disbonds automatically
using the Raptor and RCA-10 or RCA-18 and a low frequency composite dual-element transducer.
结论:使用Raptor,RCA-10或者RCA-18扫查器和低频双晶探头,可自动检测管道
和容器与其内衬的脱胶。
上一篇:
暂无
下一篇:
暂无
若网站内容侵犯到您的权益,请通过网站上的联系方式及时联系我们修改或删除