IEC60529 Spray Nozzle Physical photos
The IPX3-4 Spray Nozzle is a hand-held test device to verify protection against spraying and splashing water. The water pressure can be adjusted using the flow control knob on the device to give the required flow rate. The pressure can be seen on the gauge which is conveniently positioned by the nozzle. The spray pattern of the nozzle is made to the specifications of IEC 60529. A moveable shield can be put down over a portion of the nozzle for IPX3 or moved out of the spray pattern for IPX4.
Applications:
The Spray Nozzle is an alternative to the Oscillating Tube Tester for establishing the degree of protection against ingress of water. The Spray Nozzle is intended for use on specimens that will not fit within the diameter of the Tube Tester. The primary IEC tests include IPX3 and IPX4 protection against water spraying and splashing water.
Features:
· Spray nozzle made of brass
· Pressure gauge
· Movable shield with counterweight
· Ball valve for water flow regulation
· Water filter
· Hose connector
No.
Item
parameter
1
Water supply
Water flow rate is 50~150kpa clean water without inclusion.
2
Spray nozzle parameters
external diameter: 102mM
spherical diameter: S 75.5mm
There is a middle hole and There are 24 holes in the internal circle of holes of which the included angle is 30°. There are 96 holes in the external circle of holes of which the included angle is 15°.
3
Water flow
10L/min±5%,Flow meter is adjustable
4
Range of pressure gauge
0~0.4Mpa
5
Baffle
removable
6
Pressure gauge
0~0.25MPa
7
Site requirements
Dedicated IP waterproof test room,The ground should be flat with illumination
With good function of inflow and drainage. Wall installation
Number of Holes
121
Diameter of Nozzle Holes
0.5mm
Material
Spray nozzle make of brass
Reference
IEC60529, IEC60598-1, IEC 60335-1, IEC60745-1
粤公网安备 44030602001691号
