ip3x test rod wire probe c with 1N 3N force
Basic Introduction:
1, According to: IEC61032:1997/IEC60529:2001 AND UL
2, IP3X Test Probe C ( Test Probe C) is the necessary tool to proceed protecting electric shock test of domestic and similar electrical appliances.
Technical parameters :
1. Test Probe Length :100mm
2. Test Probe Diameter:2.5mm
3. Dam- sphere Diameter:35mm
4. Handle Diameter:10mm
5. Handle Length 100mm
6. According to IEC61032 figure 3 (the Test probe C), table 6.
Application:
1, Standard test refers to the joint part can't touch the live parts or close to the hazardous parts, and 35mm circular baffle cannot enter .
2, In the test requirement for preventing from approaching to the hazardous parts, Test Probe C/D need to exert a 3±0.3N or 1±0.1N force.
Purpose:
This probe is aiming at verifying the basic protection against approaching to hazardous parts.
Note:For the without force products,please use with the dynamometer.
IEC60529 IP4X Test Probe D with 1N force
Basic Introduction:
1, According to: IEC61032:1997/IEC60529:2001 AND UL
2, IP4X Test Probe D ( Test Probe D) is the necessary tool to proceed protecting electric shock test of domestic and similar electrical appliances.
Technical parameters :
1, Test Probe Length :100mm
2, Test Probe Diameter:1.0mm
3,Dam- sphere Diameter:35mm
4,Handle Diameter:10mm
5,Handle Length 100mm
6, According to IEC61032 figure 4 (the Test probe D)
Application:
1, Standard test refers to the joint part can't touch the live parts or approachi to the hazardous parts, 30mm circular baffle cannot enter .
2,In the test requirement for preventing from approaching to the hazardous parts, Test Probe D need to exert a thrust 1±0.1N
Purpose:
This probe is aiming at verifying the basic protection against approaching to hazardous parts.
Note:
For the without force products,please use with the dynamometer.
