光伏电缆 PV1-F 2*4 安徽锦华电气有限公司

如果您对该产品感兴趣的话，可以
产品名称：光伏电缆 PV1-F 2*4
产品型号：
产品展商：其它品牌
产品文档：无相关文档

简单介绍

光伏电缆 PV1-F 2*4 本产品适用于石油化工厂火炬点火装置专用，其产品具有质量稳定，绝缘性能高，耐腐蚀，耐高温，瞬间耐压强度高等优点。 This cable, which is used as special conductive accessories of torch igniting equipment in petrochemical refineries, has features of stable quality, high insulation performance, corrosion resistance, high temperature resistance, long service life and so on.. 一、产品执行标准企标 Executive standard: enterprise standard 二、型号 Type

产品描述

高压点火电缆
High Voltage Igniting Wire For Torch Equipment
本产品适用于石油化工厂火炬点火装置专用，其产品具有质量稳定，绝缘性能高，耐腐蚀，耐高温，瞬间耐压强度高等优点。
This cable, which is used as special conductive accessories of torch igniting equipment in petrochemical refineries, has features of stable quality, high insulation performance, corrosion resistance, high temperature resistance, long service life and so on..

一、产品执行标准企标
Executive standard: enterprise standard
二、型号
Type
ZHT-HGFBF-- 高压点火电缆
ZHT-HGFBF-- type high voltage igniting wire for torch equipment
三、规格尺寸
specification

导体标称截面 Nominal cross section area of conductor	导体*少根数 Min. pieces of conductor	护套标称厚度 Nominal thickness of sheath	成品参考外径 Outer diameter of finished cable for reference
18AWG	16/0.25	0.6	7.0

注：其它规格根据用户需要确定。
Note: other specifications depend on customer’s requirements.
四、技术要求
technical requirements
1、成品电线经受交流50HZ，15KV电压试验5min,不击穿。
Finished cable shall endure A.C. 50HZ and 15KV voltage test for 5 min without puncture.
2、电线经受热收缩试验，收缩率应不超过2%。电线表面应不出现裂纹。
Cable shall endure heat shrinkable test; shrinkable ratio shall be no more than 2%; no cracks appear on the surface of cable.
3、电线经受燃烧试验合格。
Cable shall be qualified to withstand burning test.
4、绝缘电阻每米不小于5MΩ。
Insulated resistance per meter shall be no less than 5MΩ.
五、电缆示意图
The figure of cable structure

1.导体Conductor 2.耐高温绝缘high temperature resistant insulation

3. 耐高温编织隔离层high temperature resistant braiding separating layer
4. 耐高温护套high temperature resistant sheath
六、注意事项
Notes:
施工时严格防止电缆损伤，降低产品性能。
Cable damage and performance reduction are strictly prevented during installation.
七、交货要求
Delivery requirement
成品电缆允许根据双方协议长度交货；长度误差不超过±5%。
Delivery length of finished cable depends on both agreements with length error allowance of ±5%.

产品留言

标题

联系人

联系电话

内容

验证码

点击换一张

注：1.可以使用快捷键Alt+S或Ctrl+Enter发送信息!
2.如有必要,请您留下您的详细联系方式!

温馨提示：为规避购买风险，建议您在购买前务必确认供应商资质与产品质量。
免责申明：以上内容为注册会员自行发布，若信息的真实性、合法性存在争议，平台将会监督协助处理，欢迎举报

产品目录

产品资料

光伏电缆 PV1-F 2*4