培养方法
传代方法 将旧培养液吸除,PBS清洗两遍后,加入6mL(/100mm皿)胰酶,在显微镜下观察,期间禁止摇晃培养皿,细胞刚有脱落时,则吸除大部分胰酶,留约0.5mL,移至培养箱消化,约2min取出。传代用12mL CM1-1培养液终止消化,轻轻吹打均匀细胞,后可分3~6皿培养;
生长条件 37℃,5%CO2,CM1-1培养液。CM1-1培养液:90%DMEM-H+10%FBS。DMEM-H:DMEM高糖培养液,含谷氨酰胺,含丙酮酸钠。
存储条件 冻存则用6mL冻存液(90%FBS+10%DMSO)终止消化,吹打均匀,分为6支冻存管,用程序降温盒于-80℃冻存,过夜转移至液氮中保存。
产品名称
|
规格
|
货号
|
小鼠精原细胞系
|
1×106
|
BH-X019636
|
我司常期代理ATCC Acris abcam cst Biorbyt santa Novus sigma lifespan NEB roche ABI R&D millipore BD Qiagen Cayman Jackson Life GeneTex Bio-Rad DSHB tocris peprotech 等品牌;部分产品现货,超低比价,货期短,价格优,公司产品仅用于科研售后齐全。
培养操作步骤 :
1.用盖片镊将盖玻片自75%乙醇中取出,用无菌丝绸布擦拭干净,不要用纱布;
2.将盖玻片轻���放入6孔培养板(每孔一片)或培养皿中(每个平皿可放置2-3片);
3.在距离紫外灯直射范围内20-30 厘米处照射2-3小时;
4.将经过计数的细胞悬浮液移入培养板中,使盖玻片完全浸在培养液中;
5.将培养板在5% CO2水浴孵箱中37℃孵育2-3天,当贴壁细胞生长至覆盖培养板底部2/3面积时,将培养板取出,用盖片镊轻轻取出盖玻片,用蒸馏水漂洗后即可进行快速固定以及细胞化学检测。
细胞培养方法:
1、细胞传代:细胞密度达到80-90%时即可传代
①弃去培养上清,用PBS或生理盐水清洗1-2次;
②加入2ml0.25%胰酶(T25瓶),使胰酶覆盖整个瓶或皿,盖好放入培养箱消化;
③1-2min后,显微镜下观察细胞,若大部分细胞回缩且有少量细胞脱落,轻轻吹打下确认消化情况后加入完全培养基终止消化;若细胞还是贴壁,放回培养箱继续消化至可以轻轻吹打下为止;
④将细胞悬液1000RPM左右条件下离心4min,弃上清;
⑤用新鲜培养基重悬后加入培养瓶或皿中,T25培养瓶加6-8ml培养基;
⑥悬浮细胞直接离心收集,细胞沉淀重悬后分到新培养瓶中。
2、细胞复苏:
①将冻存管在37℃温水中快速摇晃融化,时间1min左右,加入4-5ml培养基混匀。
②在1000RPM左右条件下离心4min,弃上清,加1-2ml培养基吹匀,将细胞悬液加入培养瓶中,补加适量培养基。
3、细胞冻存:待细胞生长状态良好时进行细胞冻存保种
①弃去培养上清,用PBS或生理盐水清洗1-2次,加入1mL 0.25%胰蛋白酶(T25瓶)
②1-2min后,显微镜下观察细胞,大部分细胞回缩且有少量细胞脱落,轻轻吹打下确认消化情况后加入完全培养基终止消化;
③将细胞悬液1000RPM左右条件下离心4min,弃上清,加1ml冻存液重悬细胞;
④将冻存管放入程序降温盒,放入-80℃冰箱,4小时后将冻存管转入液氮罐储存。
克隆类型 polyclonal
交叉反应 Human, Mouse, Rat, Chicken, Dog, Pig, Cow, Horse, Sheep
产品类型 一抗
研究领域 细胞生物 神经生物学 G蛋白偶联受体 G蛋白信号
蛋白分子量 predicted molecular weight: 44kDa
性 状 Lyophilized or Liquid
免 疫 原 KLH conjugated synthetic peptide derived from human OA1
亚 型 IgG
纯化方法 affinity purified by Protein A
储 存 液 Preservative: 15mM Sodium Azide, Constituents: 1% BSA, 0.01M PBS, pH 7.4
产品应用 WB=1:100-500 ELISA=1:500-1000 IHC-P=1:100-500 IHC-F=1:100-500 ICC=1:100-500 IF=1:100-500
(石蜡切片需做抗原修复)
not yet tested in other applications.
optimal dilutions/concentrations should be determined by the end user.
保存条件 Store at -20 °C for one year. Avoid repeated freeze/thaw cycles. The lyophilized antibody is stable at room temperature for at least one month and for greater than a year when kept at -20°C. When reconstituted in sterile pH 7.4 0.01M PBS or diluent of antibody the antibody is stable for at least two weeks at 2-4 °C.
Important Note This product as supplied is intended for research use only, not for use in human, therapeutic or diagnostic applications.
产品介绍 G protein-coupled receptors (GPRs or GPCRs), are members of the largest protein family and play a role in many different stimulus-response pathways. G-protein coupled receptors mediate extracellular signals into intracellular signals (G-protein activation). They respond to a great variety of signaling molecules, including hormones, neurotransmitters and other proteins and peptides. GPR143, also designated ocular albinism type 1 protein (OA1), is detected exclusively in pigment cells. OA1, which is a multi-pass membrane protein, is a melanosomal protein expressed primarily in pigment cells. Defects in the gene encoding for OA1 cause ocular albinism, an X-linked disorder mainly characterized by retinal hypopigmentation and visual impairment.
Function : Receptor for tyrosine, L-DOPA and dopamine. After binding to L-DOPA, stimulates Ca(2+) influx into the cytoplasm, increases secretion of the neurotrophic factor SERPINF1 and relocalizes beta arrestin at the plasma membrane; this ligand-dependent signaling occurs through a G(q)-mediated pathway in melanocytic cells. Its activity is mediated by G proteins which activate the phosphoinositide signaling pathway. Plays also a role as an intracellular G protein-coupled receptor involved in melanosome biogenesis, organization and transport.
小鼠精原细胞系蕈碱型乙酰胆碱受体亚型M3检测试剂盒蓖麻油酸 分析标准品,99%芦荟大黄素 分析标准品
端粒酶检测试剂盒D-核糖-5-磷酸二钠盐 95%芦荟大黄素 95%
端粒酶逆转录酶检测试剂盒(R)-1-氨基-8-(二苯基膦)-1,2,3,4 -四氢 97%雷公藤红素 分析标准品,≥98%
对称性二甲基精氨酸检测试剂盒海藻酸钠 生化级,用于固定、酶等梓 分析标准品,≥97% (HPLC)
对氧磷酶检测试剂盒天狼星玫红,BB AR梓 ≥97% (HPLC)
对氧磷酶1检测试剂盒亚磷酸钠,五水 AR1-脱氧野尻霉素 分析标准品,≥95%
多巴检测试剂盒7B 95%脱水穿心莲内酯 分析标准品,≥98%
实验要点及说明:
1.本方法适用于贴壁细胞培养,而不适用于悬浮细胞培养,悬浮细胞可使用滴片法;
2.所使用的盖玻片应该为玻璃**,并经过铬酸洗液处理;
3.盖玻片非常薄,易碎,取放盖玻片时动作要轻;
4.如果需要更多生长状态一致的细胞,可以使用较大的培养皿,但不宜过大,以避免培养液的浪费和增加污染机率;
5.如果细胞贴壁生长能力较差,可将盖玻片在0.5%多聚赖氨酸溶液中浸泡5-10分钟并自然晾干。