培养方法
传代方法 将旧培养液吸除,PBS清洗两遍后,加入6mL(/100mm皿)胰酶,在显微镜下观察,期间禁止摇晃培养皿,细胞刚有脱落时,则吸除大部分胰酶,留约0.5mL,移至培养箱消化,约2min取出。传代用12mL CM1-1培养液终止消化,轻轻吹打均匀细胞,后可分3~6皿培养;
生长条件 37℃,5%CO2,CM1-1培养液。CM1-1培养液:90%DMEM-H+10%FBS。DMEM-H:DMEM高糖培养液,含谷氨酰胺,含丙酮酸钠。
存储条件 冻存则用6mL冻存液(90%FBS+10%DMSO)终止消化,吹打均匀,分为6支冻存管,用程序降温盒于-80℃冻存,过夜转移至液氮中保存。
产品名称
|
规格
|
货号
|
iPS细胞专用因子Y27632(相关3)
|
1mg
|
BH-X019929
|
我司常期代理ATCC Acris abcam cst Biorbyt santa Novus sigma lifespan NEB roche ABI R&D millipore BD Qiagen Cayman Jackson Life GeneTex Bio-Rad DSHB tocris peprotech 等品牌;部分产品现货,超低比价,货期短,价格优,公司产品仅用于科研售后齐全。
培养操作步骤 :
1.用盖片镊将盖玻片自75%乙醇中取出,用无菌丝绸布擦拭干净,不要用纱布;
2.将盖玻片轻轻放入6孔培养板(每孔一片)或培养皿中(每个平皿可放置2-3片);
3.在距离紫外灯直射范围内20-30 厘米处照射2-3小时;
4.将经过计数的细胞悬浮液移入培养板中,使盖玻片完全浸在培养液中;
5.将培养板在5% CO2水浴孵箱中37℃孵育2-3天,当贴壁细胞生长至覆盖培养板底部2/3面积时,将培养板取出,用盖片镊轻轻取出盖玻片,用蒸馏水漂洗后即可进行快速固定以及细胞化学检测。
细胞培养方法:
1、细胞传代:细胞密度达到80-90%时即可传代
①弃去培养上清,用PBS或生理盐水清洗1-2次;
②加入2ml0.25%胰酶(T25瓶),使胰酶覆盖整个瓶或皿,盖好放入培养箱消化;
③1-2min后,显微镜下观察细胞,若大部分细胞回缩且有少量细胞脱落,轻轻吹打下确认消化情况后加入完全培养基终止消化;若细胞还是贴壁,放回培养箱继续消化至可以轻轻吹打下为止;
④将细胞悬液1000RPM左右条件下离心4min,弃上清;
⑤用新鲜培养基重悬后加入培养瓶或皿中,T25培养瓶加6-8ml培养基;
⑥悬浮细胞直接离心收集,细胞沉淀重悬后分到新培养瓶中。
2、细胞复苏:
①将冻存管在37℃温水中快速摇晃融化,时间1min左右,加入4-5ml培养基混匀。
②在1000RPM左右条件下离心4min,弃上清,加1-2ml培养基吹匀,将细胞悬液加入培养瓶中,补加适量培养基。
3、细胞冻存:待细胞生长状态良好时进行细胞冻存保种
①弃去培养上清,用PBS或生理盐水清洗1-2次,加入1mL 0.25%胰蛋白酶(T25瓶)
②1-2min后,显微镜下观察细胞,大部分细胞回缩且有少量细胞脱落,轻轻吹打下确认消化情况后加入完全培养基终止消化;
③将细胞悬液1000RPM左右条件下离心4min,弃上清,加1ml冻存液重悬细胞;
④将冻存管放入程序降温盒,放入-80℃冰箱,4小时后将冻存管转入液氮罐储存。
克隆类型 polyclonal
交叉反应 Human, Mouse, Rat, Dog, Cow, Horse, Rabbit
产品类型 一抗 磷酸化抗体
研究领域 肿瘤 细胞生物 信号转导 细胞凋亡 转录调节因子 激酶和磷酸酶
蛋白分子量 predicted molecular weight: 30kDa
性 状 Lyophilized or Liquid
免 疫 原 KLH conjugated synthesised phosphopeptide derived from human AMPK beta 1 around the phosphorylation site of Ser182
亚 型 IgG
纯化方法 affinity purified by Protein A
储 存 液 0.01M PBS, pH 7.4 with 10 mg/ml BSA and 0.1% Sodium azide
产品应用 WB=1:100-500 ELISA=1:500-1000 IP=1:20-100 IHC-P=1:100-500 IHC-F=1:100-500 IF=1:100-500
(石蜡切片需做抗原修复)
not yet tested in other applications.
optimal dilutions/concentrations should be determined by the end user.
保存条件 Store at -20 °C for one year. Avoid repeated freeze/thaw cycles. The lyophilized antibody is stable at room temperature for at least one month and for greater than a year when kept at -20°C. When reconstituted in sterile pH 7.4 0.01M PBS or diluent of antibody the antibody is stable for at least two weeks at 2-4 °C.
Important Note This product as supplied is intended for research use only, not for use in human, therapeutic or diagnostic applications.
产品介绍 The protein encoded by this gene is a regulatory subunit of the AMP-activated protein kinase (AMPK). AMPK is a heterotrimer consisting of an alpha catalytic subunit, and non-catalytic beta and gamma subunits. AMPK is an important energy-sensing enzyme that monitors cellular energy status. In response to cellular metabolic stresses, AMPK is activated, and thus phosphorylates and inactivates acetyl-CoA carboxylase (ACC) and beta-hydroxy beta-methylglutaryl-CoA reductase (HMGCR), key enzymes involved in regulating de novo biosynthesis of fatty acid and cholesterol. This subunit may be a positive regulator of AMPK activity. The myristoylation and phosphorylation of this subunit have been shown to affect the enzyme activity and cellular localization of AMPK. This subunit may also serve as an adaptor molecule mediating the association of the AMPK complex. [provided by RefSeq, Jul 2008].
Function : Non-catalytic subunit of AMP-activated protein kinase (AMPK), an energy sensor protein kinase that plays a key role in regulating cellular energy metabolism. In response to reduction of intracellular ATP levels, AMPK activates energy-producing pathways and inhibits energy-consuming processes: inhibits protein, carbohydrate and lipid biosynthesis, as well as cell growth and proliferation. AMPK acts via direct phosphorylation of metabolic enzymes, and by longer-term effects via phosphorylation of transcription regulators. Also acts as a regulator of cellular polarity by remodeling the actin cytoskeleton; probably by indirectly activating myosin. Beta non-catalytic subunit acts as a scaffold on which the AMPK complex assembles, via its C-terminus that bridges alpha (PRKAA1 or PRKAA2) and gamma subunits (PRKAG1, PRKAG2 or PRKAG3).
iPS细胞专用因子Y27632(相关3)三肽基肽酶I检测试剂盒库仑法酮测定阴用卡尔费休试 用作有隔膜阴电解液2,5-二甲基呋喃 99%
包虫病IgG抗体检测试剂盒单组份无吡啶卡尔费休滴定剂 5mg水/ml,测水量较高样品香草酸乙酯 97%
热休克蛋白90β1检测试剂盒单组份无吡啶卡尔费休滴定剂 2mg水/ml,测含水量较低样品4-乙基辛酸 98%
脂质运载蛋白-2检测试剂盒异 >99.0%(GC)2-乙烷基-3,5-二甲基吡 99%
甲型肝炎病抗体检测试剂盒异 >93.0%(GC)糠基硫 98%
镰状疟原虫IgG抗体检测试剂盒异 CP,98.0%糠基硫 97%
镰状疟原虫IgM抗体检测试剂盒二异 98%乙酸糠硫酯 99%
实验要点及说明:
1.本方法适用于贴壁细胞培养,而不适用于悬浮细胞培养,悬浮细胞可使用滴片法;
2.所使用的盖玻片应该为玻璃**,并经过铬酸洗液处理;
3.盖玻片非常薄,易碎,取放盖玻片时动作要轻;
4.如果需要更多生长状态一致的细胞,可以使用较大的培养皿,但不宜过大,以避免培养液的浪费和增加污染机率;
5.如果细胞贴壁生长能力较差,可将盖玻片在0.5%多聚赖氨酸溶液中浸泡5-10分钟并自然晾干。