培养方法
传代方法 将旧培养液吸除,PBS清洗两遍后,加入6mL(/100mm皿)胰酶,在显微镜下观察,期间禁止摇晃培养皿,细胞刚有脱落时,则吸除大部分胰酶,留约0.5mL,移至培养箱消化,约2min取出。传代用12mL CM1-1培养液终止消化,轻轻吹打均匀细胞,后可分3~6皿培养;
生长条件 37℃,5%CO2,CM1-1培养液。CM1-1培养液:90%DMEM-H+10%FBS。DMEM-H:DMEM高糖培养液,含谷氨酰胺,含丙酮酸钠。
存储条件 冻存则用6mL冻存液(90%FBS+10%DMSO)终止消化,吹打均匀,分为6支冻存管,用程序降温盒于-80℃冻存,过夜转移至液氮中保存。
产品名称
|
规格
|
货号
|
原代内皮祖细胞培养体系
|
100ml/500ml
|
BH-X019958
|
我司常期代理ATCC Acris abcam cst Biorbyt santa Novus sigma lifespan NEB roche ABI R&D millipore BD Qiagen Cayman Jackson Life GeneTex Bio-Rad DSHB tocris peprotech 等品牌;部分产品现货,超低比价,货期短,价格优,公司产品仅用于科研售后齐全。
培养操作步骤 :
1.用盖片镊将盖玻片自75%乙醇中取出,用无菌丝绸布擦拭干净,不要用纱布;
2.将盖玻片轻轻放入6孔培养板(每孔一片)或培养皿中(每个平皿可放置2-3片);
3.在距离紫外灯直射范围内20-30 厘米处照射2-3小时;
4.将经过计数的细胞悬浮液移入培养板中,使盖玻片完全浸在培养液中;
5.将培养板在5% CO2水浴孵箱中37℃孵育2-3天,当贴壁细胞生长至覆盖培养板底部2/3面积时,将培养板取出,用盖片镊轻轻取出盖玻片,用蒸馏水漂洗后即可进行快速固定以及细胞化学检测。
细胞培养方法:
1、细胞传代:细胞密度达到80-90%时即可传代
①弃去培养上清,用PBS或生理盐水清洗1-2次;
②加入2ml0.25%胰酶(T25瓶),使胰酶覆盖整个瓶或皿,盖好放入培养箱消化;
③1-2min后,显微镜下观察细胞,若大部分细胞回缩且有少量细胞脱落,轻轻吹打下确认消化情况后加入完全培养基终止消化;若细胞还是贴壁,放回培养箱继续消化至可以轻轻吹打下为止;
④将细胞悬液1000RPM左右条件下离心4min,弃上清;
⑤用新鲜培养基重悬后加入培养瓶或皿中,T25培养瓶加6-8ml培养基;
⑥悬浮细胞直接离心收集,细胞沉淀重悬后分到新培养瓶中。
2、细胞复苏:
①将冻存管在37℃温水中快速摇晃融化,时间1min左右,加入4-5ml培养基混匀。
②在1000RPM左右条件下离心4min,弃上清,加1-2ml培养基吹匀,将细胞悬液加入培养瓶中,补加适量培养基。
3、细胞冻存:待细胞生长状态良好时进行细胞冻存保种
①弃去培养上清,用PBS或生理盐水清洗1-2次,加入1mL 0.25%胰蛋白酶(T25瓶)
②1-2min后,显微镜下观察细胞,大部分细胞回缩且有少量细胞脱落,轻轻吹打下确认消化情况后加入完全培养基终止消化;
③将细胞悬液1000RPM左右条件下离心4min,弃上清,加1ml冻存液重悬细胞;
④将冻存管放入程序降温盒,放入-80℃冰箱,4小时后将冻存管转入液氮罐储存。
保存条件 Store at -20 °C for one year. Avoid repeated freeze/thaw cycles. The lyophilized antibody is stable at room temperature for at least one month and for greater than a year when kept at -20°C. When reconstituted in sterile pH 7.4 0.01M PBS or diluent of antibody the antibody is stable for at least two weeks at 2-4 °C.
Important Note This product as supplied is intended for research use only, not for use in human, therapeutic or diagnostic applications.
产品介绍 P4HB, Prolyl 4 hydroxylase subunit beta, is a multifunctional and highly abundant enzyme that belongs to the protein disulfide isomerase family. When present as a tetramer consisting of two alpha and similarity). Binds UBQLN1. Binds to CD4, and upon -1 binding to the cell membrane, is part of a P4HB/PDI-CD4-CXCR4-gp120 complex.
Subcellular Location : Endoplasmic reticulum lumen. Melanosome. Cell membrane; Peripheral membrane protein (Potential). Note=Highly abundant. In some cell types, seems to be also secreted or associated with the plasma membrane, where it undergoes constant shedding and replacement from intracellular sources (Probable). Localizes near CD4-enriched regions on lymphoid cell surfaces. Identified by mass spectrometry in melanosome fractions from stage I to stage IV.
Similarity : Belongs to the protein disulfide isomerase family.
Contains 2 thioredoxin domains.
Database links : UniProtKB/Swiss-Prot: P07237.3
英文名称 Anti-PKA C alpha+beta
中文名称 蛋白激酶C抗体
别 名 PKA C beta; PKACB; PRKACB; Protein kinase cAMP dependent catalytic beta.
浓 度 1mg/1ml
规 格 0.1ml/100μg 0.2ml/200μg
抗体来源 Rabbit
克隆类型 polyclonal
交叉反应 Human, Mouse, Rat, Chicken, Dog, Pig, Cow
产品类型 一抗
原代内皮祖细胞培养体系梅螺旋体IgM抗体检测试剂盒硅粉 99.99%4-羟基 98%
梅螺旋体Igg抗体检测试剂盒D-天冬氨酸 98%N-甲基-D-葡糖 99%
信号传导子及转录激活子5检测试剂盒D-氨酸 98%芝麻酚 98%
磷酸化信号传导子及转录激活子5检测试剂盒D-天冬酰,一水 99%邻苯二甲酰亚 CP,98.0%
EB病Rta蛋白检测试剂盒D-谷氨酸 98%邻苯二甲酰亚 99%
EB病Rta蛋白检测试剂盒D-酸 99%2-乙基-3-甲基吡 99%
异柠檬酸脱氢酶2检测试剂盒L-高脯氨酸 98%2-乙基-3-甲基吡 ≥98%, FCC, Kosher, FG
实验要点及说明:
1.本方法适用于贴壁细胞培养,而不适用于悬浮细胞培养,悬浮细胞可使用滴片法;
2.所使用的盖玻片应该为玻璃**,并经过铬酸洗液处理;
3.盖玻片非常薄,易碎,取放盖玻片时动作要轻;
4.如果需要更多生长状态一致的细胞,可以使用较大的培养皿,但不宜过大,以避免培养液的浪费和增加污染机率;
5.如果细胞贴壁生长能力较差,可将盖玻片在0.5%多聚赖氨酸溶液中浸泡5-10分钟并自然晾干。